|
Post by mattspl on Mar 5, 2023 12:28:01 GMT
Once you’ve done a few connections and hear what the Graphene does, you’ll be eager to treat everything else you can think of.
I want to remove all connectors from my mains cables and treat the cable ends and terminals inside the connectors, but I know from terminating them all with C14 connectors to suit my regenerator, it will be a tedious job.
|
|
|
Post by MikeMusic on Mar 5, 2023 17:04:11 GMT
I was thinking about just the feed to my AM conditioner as everything comes from that The next time you get a power cut, work systematically through every power cable (both ends) and interconnect, both analogue and digital. Also speaker cables. You only need a tiny smear, no need to blacken it. The fine brush provided is excellent for getting into small connector holes and the IEC end of the power cables. Please unplug the system first! It takes 24 hours to settle and you should run the Tara signal for at least 48 hours afterwards. The outcome is better resolution and fine detail without altering the system balance towards brightness. That's quite a job ! I earnestly hope not to have any more power cuts so could plan for a time with good daylight and no interruptions I'm good using tiny amounts Assume smear all around pins and holes ?
|
|
|
Post by MikeMusic on Mar 5, 2023 17:05:29 GMT
Once you’ve done a few connections and hear what the Graphene does, you’ll be eager to treat everything else you can think of. I want to remove all connectors from my mains cables and treat the cable ends and terminals inside the connectors, but I know from terminating them all with C14 connectors to suit my regenerator, it will be a tedious job. That is even more work ! Maybe after I've done the easy bits
|
|